We consider that the quality of packing is as important as the quality of product. We never try to save cost on wood or other packing materials. Stone is normally available in various textures and finishes:

Polished:
The Most popular finish – One side is Finished by the action of the Abrasives on polishing head, gives a mirror finish on Granite, and diminishing in the reflective properties, as we go from Granite to marble and slate etc.

Shade:
We strictly maintain the shade of the merchandise as desired by the client. While producing cut to size tiles, careful batching is done even when the material is cut from the same slab / block.

Thickness:
While sawing, especially marble we take a lot of care, for the best result as it is a very brittle and pasty material. A little less carefulness and the result is taper slabs.
We maintain a very low down feed and regularly monitor the sharpness of diamonds to insure maximum tolerance of +/-0.5mm within a same slab.

Flatness / Curves:
At Mahaveer Marble Industries we have carefully controlled this very common and major problem. We never let the sawing result in slabs with a curve, which makes the fabrication/installation very difficult.
We always maintain flatness of slabs to the permissible tolerance limit.

Squarness :
We maintain Perfect square ness in cut to size materials; thanks to the automatic bridge cutting machine from Peddrine SPA & Breton SPA, Italy. We never use locally made bridge cutting machines or conventional hand driven edge cutting machines as it is far than difficult to maintain.

Shipping:
Even in F.O.B. & C.& F. shipments we consider it as our duty to investigate and inform the buyer with various options of suitable shipping lines offering best freight along with shortest transit time and satisfactory service. Our job does not just end upon loading the container. We maintain the track of container till it reaches the destination and keep the client advised of various movements/trans shipments.

Quality Control & Inspection:
At Mahaveer Marble Industries we have an in-house designed three stage quality control system which does not leave any room for mistakes or carelessness. The first stage starts at quarry level where every individual block is carefully inspected. A 3D picture is drawn displaying all the characteristics. The second stage inspection is conducted upon sawing where the material is closely inspected & various findings are properly recorded with drawings. At the final stage the polished finished product is inspected using various gadgets. A proper recording is done at this level also. Before shipping, a photograph is taken of the material and the packing of every container and a proper record is maintained.